Image 1 of 4
Image 2 of 4
Image 3 of 4
Image 4 of 4
Modular Grow Light Mounting Kit for Barrina T5 - Connector (Join 2 lights together)
This connector acts as a brace for joining to Barrina T5 grow lights together, either to work with my vertical stand or just when using more than one joined together on a shelf, this helps take some stress off of the electrical connector and strengthens the joint.
These are available in either magnetic or non magnetic options depending on your needs you can either magnet to your shelves or use a strong adhesive tape to stick to glass shelves for example. I also have other mounts available that are the same as these but shorter and work in conjunction with these if not using vertically to provide other points of contact between the light and shelf for strength and stability.
There’s a few options too for angling your lights, they come in either flat, 30 degree or 45 degree options - of you’d like a different specific angle please contact me and i’m sure I can help you with a solution.
The yellow piece you see in the pictures are the actual connector and what you’ll be buying here, I made this example in yellow for easier visibility.
Installation instructions:
Place the connector over the join of both lights, there is a cutout in the connector tabs where the edges of both lights can sit, then simply press down one side of the connector first then once thats in place press down the other side. The connector does require a little force, I use the palm of my hand to push, my other T5 mounts are a lot easier to clip on however to have a secure hold and with it holding 2 lights together it was a little tighter to fit.
These clips are made out of PETG for higher heat resistance and to cope better with the potential humidity exposure in grow setups too. Im currently offering these in both white and black to correspond with the colours that the lights come in , if you’d like a different colour please leave a note when ordering and ill see what I can do for you:)
This connector acts as a brace for joining to Barrina T5 grow lights together, either to work with my vertical stand or just when using more than one joined together on a shelf, this helps take some stress off of the electrical connector and strengthens the joint.
These are available in either magnetic or non magnetic options depending on your needs you can either magnet to your shelves or use a strong adhesive tape to stick to glass shelves for example. I also have other mounts available that are the same as these but shorter and work in conjunction with these if not using vertically to provide other points of contact between the light and shelf for strength and stability.
There’s a few options too for angling your lights, they come in either flat, 30 degree or 45 degree options - of you’d like a different specific angle please contact me and i’m sure I can help you with a solution.
The yellow piece you see in the pictures are the actual connector and what you’ll be buying here, I made this example in yellow for easier visibility.
Installation instructions:
Place the connector over the join of both lights, there is a cutout in the connector tabs where the edges of both lights can sit, then simply press down one side of the connector first then once thats in place press down the other side. The connector does require a little force, I use the palm of my hand to push, my other T5 mounts are a lot easier to clip on however to have a secure hold and with it holding 2 lights together it was a little tighter to fit.
These clips are made out of PETG for higher heat resistance and to cope better with the potential humidity exposure in grow setups too. Im currently offering these in both white and black to correspond with the colours that the lights come in , if you’d like a different colour please leave a note when ordering and ill see what I can do for you:)